Omni Lift Concentrate: Iohexol Nonionic Radio Graphic Contrast Remover

Omni Lift separates and liquefies. Omni Lift is designed to extract moisture from the air and deposit it back into the bond breaking process; this process will go on for 30 to 50 minutes. 95% of the bond breaking reaction will occur in the first 3 to 5 minutes. This will keep Iodine and Iohexol molecules from reuniting.


Omni Lift is safe to use on all metals, plastics, rubbers, floor tiles, carpets, concrete, and masonry surfaces.


Powerful micro emulsion mixes with water for a fast, safe cleaning action. It is 100% fireproof; it will not burn or support combustion.


Contains a special rust inhibitor, preventing rusting.


Contains no carbon tetra-chloride, naphtha, benzene, kerosene, alcohol, or solvents, which produce toxic fumes.


For fresh Iohexol solution spills, use a spray application; wipe off with a paper towel, cloth, or sponge. For harden Iohexol solutions, spray directly on top of the spill and wait 3 to 5 minutes. Use a small nylon brush to separate the surface and wipe off with a paper towel or cloth; use a wet sponge or towel to wipe off excess residue. If residue still remains, use the former cleaning procedures to ensure a clean surface.
For a Large, Fresh Spill Area: Pour Omni Lift directly on the fresh Iohexol solution spill. Use a mop and water to clean-up residue.
For a Large, Hard Spill Area: Pour Omni Lift directly on the harden Iohexol solution spill; wait for 5 to 7 minutes. Use a plastic scraper, nylon brush, or an automatic soft pad scrubber to loosen the hard area; follow this with a mop to soak up the solution. If stickiness still remains, use warm water and a mop to clean the floor.
For Daily Maintenance: Using a mop, use 1 part of Omni Lift to 5 parts of warm water.
For an Automatic Floor Scrubber: Use 4 to 6 fl. oz. per gallon of water. For heavy build-up and very hard film, use 12-to 16 fl. oz. per gallon of water. A second application may be required for large spill areas. If necessary, follow the second application with clean water. Use only a soft scrubbing pad with scrubber.

Wear rubber gloves and safety goggles when cleaning. Avoid skin and eye contact; eye or skin contact may cause irritation. If contact with eyes occurs, flush eyes for 5 to 10 minutes. If skin contact occurs, wash the skin with cold water and then dry; follow by applying petroleum jelly to the skin to keep the skin soft. Do not take internally or contaminate foods or drinking water; ingestion may cause gastrointestinal irritation and skin effects. If swallowed, rinse mouth with cold water and drink a glass of cold water. Do not induce vomiting; seek medical attention immediately. Store Omni Lift at room temperature. Do not mix with bleach or any other household cleaning products. If spilled, use a mop and water for clean up.