SBY PENETRATING ANTI CORROSION OIL

SBY penetrating anti corrosion oil formulated from specially processed vegetable oil and wool-wax, highly refined non- petroleum oils and selected agents to provide corrosion control, penetration, metal wetting and water displacement. The long lasting product contains no solvents, will not dry out and will penetrate to the base of all metals, providing corrosion protection from both natural and industrial atmospheres. Heavily corroded and/or frozen parts such as nuts, bolts, shafts, etc. that would normally be damaged during maintenance, can be salvaged by applying special oil.

TYPICAL PROPERTIES

APPEARANCE Clear, Straw colored liquid
FLASH POINT, BULK LIQUID (ASTM-92) Cleveland Open Cup 405°F minimum
NON-VOLATILE: 89% minimum (3 hours @ 220°F)
V.O.C Less than 1%
SPECIFIC CONDUCTIVITY Less than 10-9 ohm/cm@ 1 MHz
SPECIFIC GRAVITY 0.875-0.885 (less propellant)
EFFECT ON RUBBER ASTM D-471 @ ± 158°F 70 hours   None on neoprene, Buna-n and most ASTM D-471 @ ± 158°F 70 hours   None on neoprene, ASTM D-471 @ ± 158°F 70 hours   None on neoprene, Buna-n and most synthetics. Some swelling on natural rubber
EFFECT ON PAINT None on most painted surfaces
EFFECT ON ALUMINUM No pitting
EXTREME PRESSURE ASTM D-2782 Tim-ken Method   Fail load – 15 pounds. Wear Prevention — Characteristics: ASTM D-220 Four Ball Method 40 Kg., 1200 RPM for 1 hour @ 167°F. Results: Scar diameter of 0.49mm.
REPAINT ABILITY Contains no silicone. It is recommended that surfaces treated with SBY PAC OIL should be cleaned with hot water or steam detergent (120°F), whichever is most effective
CORROSION PROTECTION ASTM D-1735 Humidity Cabinet   Passes 50 days.

WATER REPLACEMENT
Displaces water from all metal surfaces

TOXICITY
Non-toxic, LD-50 greater than 3 grams per kilogram. Non-irritating skin response. Very slight irritation to the eyes. (Toxicity tests performed according to standard methods by an independent laboratory).

WARNING
AS: May ignite, combustible liquid. Contents under pressure. Do not puncture, incinerate or store above 120°F. Keep from open flame.

NAS: Combustible. Do not Incinerate

SPRAY NOZZLE CLEANING
Turn can upside down, point in a safe direction and spray until only propellant escapes. If spray button becomes clogged during use, pull it from the can and clean it with a fine wire or needle. Replace the button with a gentle twisting motion, keeping it pointed in a safe direction. Do not stick pins or other objects into nozzle tube.