Pages

Silane Seal – 10 SB

Silane Seal 10 Solvent Based is a deep-penetrating, breathable, organo-functonal Nano fusion RTV sealer for concrete surfaces, such as: concrete decks, driveways, natural stone, bridges, parking garages, airport runways, pavers, bricks, limestone, flag stone, parking decks and smooth precast surfaces.

Advantages:

– Prevents concrete spalling and scaling.                                    – Extremely high alkali resistant
– Dries tack-free; skid resistant surfaces.                                    – Long lasting protection for new and old concrete surfaces.
– And non-yellowing.

Technical Data:

– Silane Seal 10 has met or surpassed all of the following specifications.
– SS-W-100 C Federal specifications.
– Alberta Transportation and utility procedure (ATST2a).
– Composition: Alkyalkoxysilane in a hydrocarbon solvent.
– Active Solid: 10%.
– Solvent: Mineral spirits.
– Flash Point: 112° F (44° C).
– Shelf Life: 1 year.
– Chemical Family: Organo functional RTV Silane and Siloxane Nano fusion.

 TEST FOR  VALUE  TEST METHOD
Chloride Screened  98%  NCHRP #224 Test Method Applied 100 sq. ft./gal
Scaling Resistance  Not Scaling  ASTM-C 67250 cycle and 125 cycles
Water Absorption  0.364%  ASTM-C 642, 24 hours
Repellency Factor  98.6%  NCHRP #244 Test Method

Applications: Surface should be free of dust, debris, oil, and stains. Caulk all joints and cracks, and patch surfaces before applying.

For Vertical Surfaces: Application can be made with a low-pressure sprayer using 10 to 20 psi, or can be applied with a roller or brush. When spraying vertical surfaces, let the material run down 5 to 15 inches, saturating the surface from the contact point; spray the surface again before the surface dries.

Coverage Rate:

Bricks 200-250sq.ft/gal
Smooth Pre Cast 150-200sq.ft/gal
Flagstone 125-150sq.ft/gal
Lime Stone 100-150sq.ft/gal
Broom Finish Concrete 100-125sq.ft/gal
Pavers 100-125sq.ft/gal
Rough Exposed Aggregate 80-125sq.ft/gal
Block (high density) 75-100sq.ft/gal
Block (low density) 50-75sq.ft/gal

 

Curing Time: Silane Seal 10-SB will be dry-to-the-touch in ~2 hours. Initial cure will take 24 hours; maximum cure will require up to 7 days.

*Extremely porous surfaces may require more than one coat.

**Not recommended for polished surfaces.

***These are generalized recommendations. Actual coverage rates and product performance is to be determined by testing.

Clean Up: Use mineral spirits or toluene to clean tools and equipment.

Caution: Not recommended to be used at, or below, 40° F; store product at room temperature. Keep off glass surfaces; if contact occurs, clean immediately. Do not dilute or alter the product. Protect glass metal and other non-masonry surfaces from over spray. Use in a well-ventilated area.

KEEP OUT OF REACH OF CHILDREN!